Panasonic Lumix DMC-FZ5By: Dave EtchellsPanasonic updates its 12x optically stabilized Leica lens digicam to five megapixels. <<Shutter Lag & Cycle Time Tests :(Previous) | (Next): Camera Modes & Menus>> Page 9:Operation & User InterfaceReview First Posted: 05/09/2005 |
Operation and User Interface
The Lumix DMC-FZ5's user interface is straightforward and should present a relatively short learning curve if you read through the included manual. (Although there are a lot of features here, so I'd imagine that novice users could easily spend a couple of hours learning them all. Experienced digicam users should be able to come up to speed on the major functions in under an hour though.) I generally prefer to see external access to as many exposure controls as possible, and the DMC-FZ5 does provide a fair amount of control without resorting to the LCD menu system. The camera's Multicontroller controls a wide variety of functions independently of the LCD menu, though the menu itself is quite straightforward. As noted earlier, I also found the FZ5's menu system unusually fast to navigate.
Shutter Button: Located on the right side of the camera's top panel and
surrounded by the Zoom lever, the Shutter button sets focus and exposure when
halfway pressed, and when fully depressed, it trips the shutter release. In
Self-Timer mode, fully depressing the Shutter button triggers a two- or 10-second
countdown before the shutter is released.
Zoom Lever (see image above): Surrounding the Shutter button, this lever controls the optical and digital zoom in any Record mode.
In Review mode, pushing the lever toward the "W" end activates a nine-image index display mode. Pushing the lever to the "T" end digitally enlarges a captured image as much as 16x. When playback zoom is active, pushing the lever back toward the "W" zooms back out.
Mode Dial: To the left of the Shutter button, this notched dial is used
to select the camera's shooting modes as follows:
Program AE (P):
Places the camera in control of shutter speed and lens aperture, while you
maintain control over everything else (i.e., white balance, ISO, metering,
exposure compensation, flash, etc.).
Aperture Priority
(A): Allows you to set the lens aperture from f/2.8 to f/8.0 (depending
on the zoom setting), while the camera controls the shutter speed. In this
mode, you maintain control over all other exposure variables.
Shutter Speed Priority
(S): Allows you to control the shutter speed settings from 1/2,000 to eight seconds, while the camera controls the aperture. All other exposure settings are available. (As mentioned earlier, note that shutter speeds above 1/1,000 second are only available when smaller lens apertures are selected.)
Manual (M):
Provides complete control over all exposure settings, including shutter speed
and lens aperture.
Macro:
Places the camera into Macro mode, letting you focus on smaller objects at
a closer range.
Movie:
Records moving images with sound, at either 30 or 10 frames per second. Recording
times are limited by memory card capacity and frame rate.
SCN:
Accesses one of nine preset scene modes. (Through the setup menu, you can
opt for the last used scene mode to be automatically selected when entering
this mode, or you can set the camera to automatically present you with a menu
listing all available modes when scene mode is entered.)
Simple
Mode: This would be the "green" or "Auto" mode on other cameras, Panasonic calls it the "Simple" mode. In this mode, most user options are removed, allowing control only over image resolution (with options of "Enlarge," "4x6," or "E-Mail), Auto Review mode (on/off), Beep (off/low/high), and Clock Set. Continuous-mode options are reduced to a single choice, and instead of exposure compensation adjustments, the up arrow on the four-way controller simply toggles a Backlight option. Flash options are reduced to just Off (flash head stowed), Auto, and Auto with Red-Eye Reduction. The self-timer function is available as normal, but the image stabilizer is not.
Playback:
Lets you review captured images and movie files.
Optical Image Stabilizer Button: Directly behind the Shutter button / Zoom lever combo on the top panel, this button accesses the camera's image stabilizer function, which attempts to reduce image blurring caused by camera shake. The stabilizer can be disabled altogether, or can be set to Modes 1 or 2. In Mode 1 the stabilizer functions continuously whenever the shutter button is half-pressed. Mode 2 operates the stabilizer only during the actual image capture, which conserves power and potentially provides a slightly better chance of capturing a blur-free image (when in Mode 1, the stabilizer may already have used much of its available range to correct shake that occurred before the shutter was released, and hence may not have as much latitude to correct the shake during the actual exposure).
Burst Mode Button: Directly behind the Optical Image Stabilizer button, this button accesses the three Burst modes (High, Low, or Infinity), or returns to the single-shot mode.
Flash Release Button: Located on the rear panel, just below the pop-up
flash compartment, this spring-loaded button mechanically releases the pop-up
flash from its closed position.
Diopter Adjustment Dial: Hidden away on the left side of the optical
viewfinder eyepiece, this dial corrects the viewfinder optics for eyeglass wearers,
with a range from +4 to -4. (An unusually wide range.)
EVF/LCD Button: The first button in a series lining the top of the
rear panel, this button switches the viewfinder display between the EVF and
LCD monitors.
Display Button: To the right of the EVF/LCD button, this button controls
the image and information displays in Record and Playback modes. In Record mode,
pressing the button cycles between the five display modes, which include the
image with information, image with information and live histogram, "Out
of Frame" display, alignment grid, and image with no information modes.
In Playback mode, pressing the button cycles between the image with information, expanded information and histogram, and no information displays.
Exposure Button: On the right side of the Display button, this button lets you shift the exposure in Program AE mode. In Aperture Priority, Shutter Priority, and Manual exposure modes, pressing this button lets you adjust the aperture and/or shutter speed by pressing the button and then using the arrow keys to adjust the selected variable. (As noted in my User Notes above, I felt that this setup was a little awkward to use.) The Program Shift function that let you bias Program-mode exposures towards a faster shutter speed or smaller aperture (as found in the DMC-FZ3 camera) has been removed, which is rather a shame.
Power Switch: To the right of the Exposure button, this sliding switch
turns the camera on or off. Powering the camera on with the Mode dial set to
a record mode triggers the lens to extend. (Likewise, turning the camera off
causes the lens to retract.)
Menu Button: Next to the upper right corner of the LCD monitor is the Menu
button, which calls up the settings menus on the LCD display in all camera modes.
A second press of the Menu button cancels the menu display.
Four-Way Multicontroller: Located directly to the right of the LCD, the
Multicontroller is a four way rocker disk that accesses a variety of camera
settings. The arrow keys navigate through menu options and adjust camera settings.
In most record modes, the up arrow accesses the Exposure Compensation, Auto
Exposure Bracketing, Flash Exposure Compensation, and White Balance Adjustment
tools. The right arrow cycles through the available flash modes, while the left
arrow cycles through the Self-Timer modes. The down arrow activates a quick
review of the most recently captured image.
In Playback mode, the right and left arrow keys navigate through captured images and movie files. When an image has been digitally enlarged, the four arrow keys pan around within the image.
Delete Button: Adjacent to the lower right corner of the LCD monitor, this
button pulls up the delete menu in Playback and Review modes. When the AF trigger
option is set through the Record menu, this button is used to trigger the camera's
autofocus system, rather than the more usual half-press of the shutter button
doing so.
Follow Imaging Resource: